I’ve been trying to get Consult 3 plus V46.11.00 to work with my NEXIQ usb link.
#Nissan consult emulator how to#
Original:How to get Nissan Consult III Plus work with Ford VCM2? Posted in car diagnostic tool | Tagged nissan consult 3, nissan consult 3 clone, nissan consult 3 key programming, Nissan Consult 4, nissan consult III plus, Nissan Consult-3 plus, VCM2, ] | Leave a reply How to get Consult 3 plus work with NEXIQ usb link It seems now Clip S/W needs NEW “Pill” for Clones. Note 2: Clone Consult III (who using patch) for to working with Nissan Consult III S/W, DID NOT working with Clip Software!!! Renault Aliance VCI = 100% Same with Nissan Consult III VCI… remplaced by sonde alliance vi but what is it. The sonde alliance vi is the end for the sonde can clip RTL. !5kMm2TwI!1m7PLJEx_DM_ll3a1UBWuG4ZviRlSyH80iKvJN0-BLk In passthru 4.04 in reg edit and rename NISSAN_VI2 To something elseĬhange name Bosch Ford-VCM-II to NISSAN_VI2 In the Diagnostictool.ini put Ford-VCM-II Here is thesetup of VCM II with Nissan Consult 3+. Probably, only if use Alliance VI2, but alliance vi is quite a bit more complicated to set up I read that no matter what j2534 tool you use the Ignition ON its not seen I use AVDI and Ignition ON it is not seen too The Ignition ON its not seen if you use VCM II Others will also work but maybe not as well. And make Consult III+ to run it with Ford VCM II interface.Īll these are the best to work with Consult 3 plus. Have got the alliance vi to work with Consult3 plus software.